Paffenhoff
Gustav Paffenhoff Punching machine, type ZE
After our retro-fit in 2006 As an alternative to this
machine we recommend you take a look at our newly-designed
and patented punching machine: PZH 1
Our punching machine PZH satisfies the
most modern technological requirements. Servo-motors line
up each tooth reproducibly (to 2/100ths position accuracy).
With our patented double tooth modus, you can double your
output at one stroke.
1. Automatic punching machine model ZE
for punching the teeth of band saws and
hand saws for wood.
We offer you a general overhaul
for this type of machine or, if you like,
a complete retro-fitting.
In addition we can make you your required
spare parts at short notice if you send us the
master drawing.
2. Automatic punching machine model ZG/ZH
for broad band saws, straight and bauchige
miter saws, frame saws, etc.
We also offer a general overhaul for
this machine type
as well as for all other Paffenhoff models or, if you
prefer,
we can give you a complete retro-fitting
In addition we can make you your required
spare parts at short notice if you send us the
master drawing.
3. Tension rolling machine
With its solid construction you can roll faultless stress
zones of the greatest consistency
on this machine. Special rollers even out the deformation
of the teeth, caused by punching, and the angle of punch.
Quick adjustment of the pitch line by means of a stop
lever up to three pitch lines, further changes via adjusting
spindle with handwheel. Workpiece clamping is not necessary,
the saw blades only rest loosely on the centre pin.
|